Pipercross PX400 Air Filter, for Weber 32/36 DGV

Pipercross air filters have been used in every form of motorsport from Formula Ford to Formula 1. This compact (7" L x 5.5" W x 3.5" H) filter is small enough to work on most cars even if the bodywork or air scoop is very close fitting. The three stage foam element draws air through the top as well as the sides to allow the greatest possible air flow for its size. The integral plastic base plate fits the Weber 32/36DGV carburetor and mounts the filter parallel to the valve cover on the Ford Kent 1600 Uprated and the Ford 2.0L SOHC Pinto engines. This filter is not intended to be cleaned and re-oiled. It should be replaced at each engine rebuild, or after two racing seasons.

If the bodywork cuts into the space needed for the air filter, the filter will easily deform for clearance without adversely affecting airflow.

Pipercross PX400 Filter Mounting Instructions
 

Related products:

  Pipercross Air Filters

  Air Filters for Weber 32/36 DGV (Also DGF, DGAV, DGEV)

 
Click image for big picture

Customers who purchased this item also purchased:

Safety Retaining Washer for Rod End Bearings

AN365 Nylock Hex Nut (MS20365)

AN3 Airframe Bolt - 10-32 Thread

MS21042 Jetnut, All Metal Locknut

Open End Pulled (Blind) Rivets