|This item qualifies for FREE Shipping in the continental United States!|
Brand: AIM Sports
The GPS08 module from AiM further expands the track mapping abilities of AiM data loggers and data logging dashes. In addition, the GPS08 allows lap timing (even split times) without the use of trackside beacons, storing data for up to 50 tracks with up to 5 splits per track. The GPS08 can also calculate and log speed, lateral and longitudinal g-forces, and of course vehicle position.
This special roof-mount version is simple to install: Just drill a 12mm (1/2") hole in your roof, slip the cable through from the outside, and use the included M12 x 1.25 nut to mount the GPS antenna. Connect the CAN cable to your logger and you're ready to go. A rubber gasket on the base of the module helps to seal out wind and water. This configuration contains all of the GPS electronics inside the antenna. This solves the RFI issue that the original GPS Module had, so cable routing is less critical. The GPS unit willl even automatically configure itself during start-up!
The GPS08 is compatible with AiM MXL, MXL2/MXG/MXS, and MXM auto dashes; MyChron4/MyChron5 kart dashes, EVO3/EVO4S/EVO5 data loggers, and SmartyCam HD GP 2.2. The 4m (13 ft) cable is long enough to reach the dash in just about any car.
MXL Pro Note: The MXL Pro 05 dash requires the 22-pin MXL Pro Auxiliary Harness (not included) for CAN connections.
MyChron4/MyChron5 Note: The GPS08 module draws power from MyChron karting dashes. This can reduce the amount of battery run time available if the dash is not connected to an external power source. If your MyChron karting dash runs on internal power and is not connected to an eBox, consider using the MyChron GPS05 Module for Karts (Part No. MC-190). The kart version includes a powered hub that connects to an external battery (not included). The battery in the MyChron e-Box can also power the GPS08 module, eliminating the need for external power.
EVO4 Note: The EVO4 uses a different GPS antenna with a dedicated connector. EVO3, EVO4S, and EVO5 use the GPS08 module.
SmartyCam Note: Only the SmartyCam HD GP 2.2 takes this version. SmartyCam HD, SmartyCam HD GP, and SmartyCam HD 2.1 all require the GPS08B Module (Part No. MC-592), which has a 4-pin connector.