Gates PowerGrip SB Heat-Shrinkable Hose Clamps

Revolutionary Gates PowerGrip hose clamps eliminate the need for screwdrivers -- and even the need for retightening! The special heat-shrink polymer sleeves create a tight seal with uniform pressure all around your hose. PowerGrip clamps resist loosening throughout repeated heat cycles, making them maintenance-free. They eliminate a lot of metal and sharp edges under the hood. On top of all that, they look super-trick!

Sizes are available to fit hose ODs from 1/2" to 3 5/8" -- be sure to measure your hose OD after it is installed on the barb or nipple.

* These clamps are capable of shrinking slightly smaller than the minimum OD; however, clamping force may be reduced if the minimum OD is exceeded.

** Exceeding the max OD can cause problems on installation. Trying to force a PowerGrip Clamp over a too-large hose can cause enough friction to begin the shrinking process.