38.1mm Piston Seal for Girling 16/4 Caliper, each

This seal fits the vintage Girling 16-4 caliper, most famously used on the rear of the Lola T70 and Ford GT40 Mk IV. The 16-4 had four 38.1mm (1.50") pistons. The rubber compound is formulated to work with any DOT-rated brake fluid (not for use with hydraulic oil). These seals are sold individually (4 required per caliper).

Note 1: These seals are for Girling 16/4 calipers only. They do not fit any other brand of calipers. Brakes are a critical safety component. We strongly recommend against trying to use these seals in other brands of calipers, even if the nominal piston size is the same. The results of brake system failure can have devastating effects!

Note 2: These seals get compressed to size when they are installed in the caliper bore. This is required for a tight seal. They will be slightly oversize (up to about 0.10" larger than the nominal size) when they are loose. They will not fit tight against the piston until they are installed in the caliper bore.