Shop With Confidence - 30 Day Easy Returns - No Need To Call
Follow us on facebook

Terry Body Springs Only (Stainless), each

Click for a larger picture of Terry Body Springs Only (Stainless), each
View Catalog Page in PDF format

These well proven fasteners are one of the best ways to hold noses, fenders or other pieces of bodywork to a race car. They allow the body panels to take a little "bumping" since the springs can stretch and then pull the part back into place. They are easy to install and easy to disconnect. Stainless steel construction will not chip or rust. Approximately 3 3/4" from the center of the mounting bolt to the far edge of the hook hole when relaxed. Mounting hole diameter 9/16". Sold individually.

Note: The mating Hold Down Hooks (Part No. 3002) are sold separately.

Part No.
Stock Status
In Stock


by PowerReviews
Terry Body Springs Only (Stainless), each

(based on 1 review)

Ratings Distribution

  • 5 Stars



  • 4 Stars



  • 3 Stars



  • 2 Stars



  • 1 Stars



Reviewed by 1 customer

Displaying review 1

Back to top


Just what I needed.

By Cody311

from Tennessee

Verified Buyer

Comments about Terry Body Springs Only (Stainless), each:

I bought these for a project car that I am putting together. I needed it to hold down my trunk since I have taken out the latching mechanism. They worked fine, but these are ONLY the springs. You will need to either make your own attachment points (I did this out of some old window locking mechanisms) or purchase them separately. Overall very pleased how these turned out. Remember to measure your area to allow for tension in the spring. They are not extremely tight until you get about 3 or 4 mm of stretch into them.

Displaying review 1

Back to top