These lightweight, low-profile plates are an excellent way to install a captive nut behind a panel. They are very similar to MS21059 Floating Nut Plates, but in a metric version. (There is currently no military spec for metric nut plates.) The floating nut in these nut plates allows up to 0.75mm misalignment in assembly.
|Metric Nutplate Dimensions|
|Dash Size||Thread |
|Length ||Width ||Height ||Rivet |
|29.2mm ||13.1mm ||7.1mm ||2.5mm* |
* The specification sheet for FM5000 metric nutplates calls out 3.3mm (1/8") rivet holes. These nutplates have smaller, non-standard rivet holes. We also offer the standard Metric Floating Nutplates conforming to the FM5000 standard in more sizes (Part No. 6069).
Note: We recommend a drop of oil on the threads the first time a screw is installed in these self-locking nutplates. This is especially important in the smaller thread sizes. We have seen heads twisted off of screws due to the high installation torque even though the nutplates are coated with a solid lubricant. The initial insertion polishes the threads. This slightly lowers the torque during subsequent insertions.