Eyebolt Hardware Kit for Snap-in Driver Restraints, One Side

This kit is specifically designed for mounting driver restraints with snap-in end plates. Snap-in mounting is especially common on FIA-approved harnesses for sedans. One kit is enough to mount one end of one belt. Order 2 kits to mount both ends of a lap belt, or to mount two shoulder belts.

Each kit includes one forged 7/16-20 eyebolt (1.75" long fully-threaded shank), a matching AN365-7 lock nut, a matching AN960-716 washer, and a large-diameter AN970-8 backup washer. The AN970-8 washer provides over 3 square inches of bearing area to prevent pulling through sheet metal.

Note: Our forged steel eyebolts are much stronger than common hardware store eyebolts that are formed by bending a straight bolt into a ring. Never trust your safety to bent eyebolts!