These reusable hose ends fit our standard Braided Stainless Steel AN Racing Hose (Part No. 3270-Size) as well as Aeroquip Startlite Racing Hose (Part No. 3492-Size). The banjo design allows for a much lower-profile installation than any 90 degree hose end.
The banjo bolt (included) has male SAE/JIC threads to fit a standard SAE/JIC/AN female O-Ring Boss (ORB) port. On sizes 6AN through 12AN, the bolt is retained in the hose end by a circlip to keep the height even lower than with conventional banjo fittings. The 16AN size retains the bolt by a top nut for quick removal and reinstallation for between-run rebuilds. The hex for the bolt is located under the banjo fitting (use a thin open-end wrench to tighten). The O-ring boss size matches the AN hose size (step sizes are not available).
Includes a cutter-style banjo hose end, banjo bolt, circlip (top nut on 16AN size), and 3 O-ring seals. Anodized black aluminum.
|ORB Banjo Hose End Dimensions |
|Hose Size ||Banjo (ball) OD ||Total Height* ||Length** ||Part No. |
|-6 ||7/8" ||1.04" ||2 1/2" ||3228‑420‑06 |
|-8 ||1 1/4" ||1.28" ||3" ||3228‑420‑08 |
|-10 ||1 3/8" ||1.43" ||3 1/4" ||3228‑420‑10 |
|-12 ||1 5/8" ||1.57" ||3 9/16" ||3228‑420‑12 |
|-16 ||2 1/4" ||2.68" ||4 1/2" ||3228‑420‑16 |
* Total Height measured from below the O-ring to the top of the banjo bolt (the highest point on the assembly).
** Length measured from end of banjo ball to end of socket collar with the collar screwed on all the way.
Assembly Instructions for Steel Braided Racing Hose