Brand: Borgeson Universal Co
High-quality Borgeson steel universal joints are specifically made for steering use in demanding racing applications. The internal needle bearings provide long life, smooth operation, and great reliability without maintenance.
This size has a 3/4" ID smooth bore at one end and a GM-type 5/8-36 spline at the other.
Note: This spline is not compatible with the Chrysler 5/8-36 size or the 5/8-36 spline used on Stiletto aftermarket racks.
The splined end has a 5/16"-18 setscrew with a locknut (we suggest adding Loctite for security). A flat, groove, or indentation must be filed on the shaft where the set screw will clamp. To attach the smooth bore end, we recommend drilling the yoke for two 3/16" roll pins or hardened shear pins at right angles to each other and approximately 3/8" apart. Welding is not recommended because of the possibility of heat damage to the bearings.
Measure 1.625" OD at widest section, 3.25" overall length. Maximum operating angle is 35 degrees.
