ITG "Stubby" Bolt-On Radiused Inlet for 48 DCOE, 13mm High

Brand: Induction Technology Group

Are you so squeezed for space that you can't even fit our super-low velocity stacks on your Weber 48 DCOE? These ultra-low "stubby" stacks add just 13mm (1/2") to the front of your carb!

The bolt-on design eliminates the air horn mounting tabs. The stack can be mounted under an air filter base plate, allowing the use of a very low-profile filter. The 65mm mounting bolt spacing fits Weber 48 DCOE*; Dellorto 48 DHLA; SK 47 or 50 DBS; Mikuni 50 PHH carburetors . Sold individually.

Note: Not recommended for later Weber 48 DCO/SP. This airhorn design does not extend into the carburetor throat and will not retain the short auxiliary venturi on the 48 DCO/SP.