Order before 5:00 pm Central Time for Same Day Shipping on most In-Stock orders!
Pegasus is your source for Stilo Helmets and Accessories!
 
 
 
Check us out on Instagram
 
Shop With Confidence - 30 Day Easy Returns - No Need To Call
 
Follow us on facebook
 

Gates PowerGrip SB22 Clamp for Hose O.D. 13/16 to 15/16

Click for a larger picture of Gates PowerGrip SB22 Clamp for Hose O.D. 13/16 to 15/16
Click for a larger picture of Gates PowerGrip SB22 Clamp for Hose O.D. 13/16 to 15/16

Brand: Gates Industrial Corporation

Revolutionary Gates PowerGrip SB hose clamps eliminate the need for screwdrivers -- and even the need for retightening! The special heat-shrink polymer sleeves create a tight seal with uniform pressure all around your hose, even if the fitting is out-of-round. PowerGrip clamps resist loosening throughout repeated heat cycles, making them maintenance-free. They eliminate a lot of metal and sharp edges under the hood. On top of all that, they look super-trick!

This size fits hoses measuring 13/16" to 15/16" (21mm to 24mm) OD -- be sure to measure your hose OD after installation! This is the size recommended for our 1/2" (13mm) ID silicone hose when used with our HJ13 hose joiner.* Works with OEM molded rubber hoses or any brand of silicone hose. 3/4" (19mm) nominal width. Black only. Sold individually.

To install, slip the PowerGrip clamp collar off of its cardboard sleeve** and slip it over your hose. Install the hose over the barb and slide the PowerGrip clamp over the barb. Use a standard heat gun to shrink the clamp tightly over the hose, and you're done!

* For low pressure applications, such as a vent hose, a single PowerGrip clamp centered on the hose joiner may be sufficient. However, for the most secure connection, two clamps should be used. They can be trimmed so that they don't overlap, or overlapped as shown in the photo. It's a tight fit to get the second sleeve over the first one, but it is possible. (Be sure to let the first sleeve cool down to room temperature before trying to install the second one.)

** Keep the PowerGrip clamps on their cardboard sleeves until just before installation so that they don't begin to shrink prematurely. Crush the cardboard sleeve to let the clamp slip off. Do not try to cut the cardboard sleeve.

Qty
Part No.
Price
Stock Status
GTS-32922

Condition: New

1 to 9: $2.99 

10 & up: $2.67 

In Stock