Throttle Plate Screw, Weber 32/36 DGV Carburetor

These are the original Weber M4x0.7 x 6mm Phillips cross recess fillister ("cheese head") screws used to hold the throttle plates in the throttle shafts on the Weber DGV series carburetors. Two screws are used per shaft (2 primary plus 2 secondary, total of 4 per carburetor). Sold individually.

Fits genuine Weber 32/36 DGAV / DGEV / DGV (including DGV 5A), 32/36 DFAV / DFEV, and 40 DFI. Does not fit 38 DGAS/DGES, 40 DFAV, 40 DCNF, IDA series, IDF series, or any side-draft carburetor. Fits genuine Weber carburetors (made in Italy or made in Spain) only. Does not fit clones, copies, or carburetors made outside of Europe.