Brand: Campbell Motorsport
If you spend too much time trying to bed your brake pads, consider replacing your worn, grooved rotors! Our brake rotors are brand-new castings made in the USA exclusively for racing use. They are not repackaged street car rotors. This rotor is the same as our 3545-10, but grooved and lightened. Sold individually.
This size fits Swift DB-1 FF and DB-3 FC with LD19 calipers, and older Van Diemen with 4-bolt wheels (non-centerlock). Note that some Swift DB-3 cars were fitted with larger calipers and should use the 10" OD Brake Rotors for Swift DB-3 with LD20 Calipers (Part No. 3545-30).
|9.75"||1.63"||0.29"||3"||(4) 3/8" on 3.75" circle|
*Height is measured from the inner friction surface to the outer face of the hat. Place the rotor down on a table and measure from the table surface to the highest point on the hat.