Weld-On Adjustable Pedal Stop
Pedal stops are critical on the clutch and throttle pedals. Without one, you run the risk of bending clutch fingers or release forks, or even blowing the engine!* Even a clutch or throttle cable can stretch or snap if pulled too hard. This compact pedal stop works with virtually any type of pedal. It is designed to be installed wherever you need it. Just cut the mount tube to fit your application and weld in place. The stop rod is angled to meet your pedal and features about 1" of travel adjustment. All steel construction.
* Really! Pushing the clutch pedal past the release point with an annular slave cylinder (hydraulic release bearing) builds a powerful pressure spike in the system. This excess pressure can actually push the crankshaft forward hard enough to grind away the crankshaft thrust washer or thrust bearing. This can lead to a loss of oil pressure and engine failure.
Tilton 2- and 3-Pedal Assemblies
Clutch Release Bearings & Slave Cylinders for FF1600/FF2000
Throttle Linkages and Accessories
OBP 2- and 3-Pedal Assemblies