Enter desired order quantities below, then click the "Add selected quantities to cart" button.
Part No.: 3488-Size-Angle
Black Aluminum Barbed Hose Fitting to AN Female
These aluminum hose fittings allow you to use standard AN fittings with our Textile-Reinforced Black Rubber Hose. Each hose end has a standard female AN fitting at one end and a secure hose barb at the other.
Installation Tips:
Use Oetiker Clamps to secure the hose in place for pressurized applications.
For maximum security, use 2 Oetiker clamps on each hose end. Rotate one clamp so the ears are clocked 90 degrees to the ears on the second clamp.
Installation Method 1 (The traditional way):
1. Clamp the hose end in a vise with soft jaws. To prevent straight hose ends from spinning, screw it onto a male AN fitting first.
2. Lube the barb with clean motor oil.
3. Slide the Oetiker clamp(s) onto the hose.
4. Warm the end of the hose in boiling water for 5 to 10 seconds. This makes the rubber more pliable.
5. Slide the hose over the barbed fitting with a twisting motion.
6. Install Oetiker clamp(s).
Installation Method 2 (for straight hose ends only):
1. Place the straight hose end on the Aeroquip Socketless Hose Assembly Tool (Part No. 3158-003, sold separately).
2. Lube the barb with clean motor oil.
3. Slide the Oetiker clamp(s) onto the hose.
4. Place the hose into the jaws of the Socketless Hose Assembly Tool.
5. Squeeze the handles together to grasp the hose firmly and pull the third handle to drive the hose end into the hose.
Installation Method 3 (the modern way):
1. Use our Koul Tools EZ-ON Hose Press (Part No. 3330-001, sold separately).
Pegasus Auto Racing Supplies, Inc.
2475 S 179th St
New Berlin WI 53146 USA
• Order Toll Free: 1-800-688-6946 (US & Canada)
Local/International Order Line: 262-317-1234
