Bell RS7 Carbon Helmet, Snell SA2025, FIA 8859-2024

Brand: Bell Racing

The RS7 Ultra is a carbon-fiber helmet based on the Bell HP7 helmet used extensively in Formula 1 and developed with input from Formula 1 drivers. The lightweight carbon fiber shell has a very narrow eyeport. Flow-through ventilation is accomplished by special channels in the liner and a total of 14 inlet and outlet vents (2 inlets in the chin bar, 2 inlets above the visor, 8 inlets in the crown, and 2 exhaust outlets in the rear of the shell). The shield friction slider screws and the shield hold-down post have been moved down below the shield pivot screws for better aerodynamic and acoustic performance.

The RS7 Ultra features a full carbon-fiber shell and includes HANS® post anchors factory-installed. Available in carbon fiber color only (the carbon weave shows through the clear epoxy resin). Includes one clear DSAF (dual-pane, anti-fog) shield with a color-keyed visor strip, a hex wrench for the shield hardware, and a drawstring helmet bag. Snell SA2025 and FIA 8859-2024 approved.

SA2025 is the latest Snell Foundation rating for automotive racing helmets. This helmet rating has been developed to provide the best safety protection for auto racing drivers who are restrained in their vehicles. SA2025 helmets are tested for flame retardance, and additional tests ensure that the factory-installed M6 threaded inserts can handle loads from an FHR. An SA-rated helmet may not meet DOT specifications for street use, such as on motorcycles.

SIZING: Helmets should fit as snug as possible without causing discomfort. Measure head circumference around the largest part of the head approximately one inch above the eyebrows and just above the ears. If a one or two layer Nomex hood will be worn with the helmet, it should be worn when measuring head circumference. If a hood is not available, add about 1/4 inch to the circumference measurement for a single layer hood and 1/2 inch for a double layer hood.

Accessories and replacement parts:
Bell SE07 Dual Pane Anti-Fog Helmet Shield, Part No. 2312-012 (one clear shield with matching visor strip included with helmet)
XStack Tear-Off Shields for Bell SE07 Shield Part No. 2307-008 (sold separately)
Spare Parts Kit for SV SE07 Pivot Part No. 2239-012 (sold separately)