Banjo Bolts With Integral Brake Light Switch
These clever banjo bolts allow you to install a pressure-activated brake light switch without adding a tee fitting. Simply replace an existing banjo bolt in your system with one of these pre-wired bolts. The pigtail leads are approximately 10 inches long for easy two-wire hookup.
Note: The amperage rating of these compact switches is quite low. They should never be used to switch on brake lights directly. Only use them to trigger a brake light relay (sold separately).
Recent Top Seller for this product group
Our soft annealed Copper Crush Washers are ideal for sealing brake unions. Both the fitting and port must have adequately large flat sealing surfaces to ensure a reliable seal.
|$12.99*||Not In Stock|
* Quantity Pricing Available